CubePilot Herelink Air Unit

• 1x Herelink Air Unit
• 1x Herelink Mounting Plate
• 1x Herelink Screw Set
• 1x Herelink Silicone Ring Set
• 2x Herelink Taoglas Antenna
• 1x Herelink Fan
• 1x Herelink Cable Set
• 1x Herelink HDMI Cable
• 1x Herelink Set up tips card

Size

• 76.7 x 27 mm

Apparance

• Main board + video daughterboard + RF daughterboard
• Video daughterboard designed for bridging HDMI signal input
• RF daughterboard designed for transceiver transmission RF signal
• Use M2 (E) connector to connect daughterboard and main board
• 2 x Micro HDMI interface (foreside): For external camera video signal input
• 1 x 2 pin connector interface (side): Include one 5V – 12V Power Input Interface
• 1 x 3 pin connector interface (side): Include one 3.3V / 5V Level UART interface
• 1 x 4 pin connector interface (side): Include two 3.3V level RC output interfaces (SBus / IBus output, optional control)
• 1 x Micro USB interface (side) Debug & upgrade | support OTG
• 2x indicator light (side): Indicate status of pairing connection and transmission
• 2 x MMCX antenna interface: For transmission between ground system and air system

Ix Key (side)

• One button pairing connection setup between air system and ground system
• Auto channel selection for better performance; Fast connection recovery in milliseconds

Interface

• Processor: SoC – pinecone SI AP: 4x big cores, Cortex A53 at 2.2 GHz | 4x small cores Cortex A53 at 1.4 GHz | GPU: 4 cores, Mali-T860 | SDR: A7 + DSP
• Storage: LPDDR3: 1 GB | eMMC: 4 GB
• Bandwidth: 20 MHz / 10 MHz
• Transmission Range: FCC 20 km CE / SRRC 12 km
• Latency: minimum 110 ms (from input source to ground control screen display)
• Video Resolution: 720p at 30 fps | 1080p at 30/60 fps
• Operating Frequency: 2.46 GHz ISM
• Receiver Sensitivity: -99 dBm at 20 MHz BW
• Interference Recovery: < Is
• Power Consumption: Average below 4 W
• Weight: 520 g