Beeptoolkit S – IDE Soft Controller

Software (installation package) 175 MB

Input USB ADC module, 8 channels, 70mm x 35mm

Output USB logic module, 16 channels, 70mm x 23mm

• Save Config.gif
• SCENARIOS OPTIONS.gif
• Map R&D pannel.png

BEEPTOOLKIT S- IDE Soft Controller :

is optimized for use on low-cost devices that support the basic architecture of Windows 10 LTSC.

Its low disk space requirements (less than 175 MB) and memory usage (less than 30% of 4 GB RAM)

make it suitable for both tablets and industrial PCs (IPCs), providing flexibility and democratizing the automation process.

To properly display the user interface, make sure your monitor supports and is configured to a resolution of at least 1920×1080.

+USB 8-channels ADC sampling modules:

We use these great, low cost and commercially available modules as a USB hardware input interface for analog resistive or TTL sensors.

Including 8-channel AD sampling voltage inputs GND: Negative/common ground interface of the sampling voltage.

Up to 12-bit AD acquisition channels (4096 resolution = 0.001 V). Usage: Install the CH340 USB serial chip driver on the PC, connect the module to the PC, IN screw terminals connect to the positive end of the sampling voltage, GND connect to the negative end of the sampling voltage (ie, handling common ground), configure the USB connection ID of the COM ports in relation to the I/O ports of the BEEPTOOLKIT. Baud rate (115200) allows you to see the AD sampling results, the sampling results are updated once every 200 ms.

*The received voltage cannot exceed !3.3V, otherwise there is a risk of chip damage.

** The starter pack includes 1 module for 8 channels and the CH340 driver installation file.

+USB Output Interface 16 Channel:

The logical core of the platform, in accordance with your control scenario, allows you to configure 16 channels in any sequence logical signals with 2-bit resolution for each output as “0” = 0…0.4 V and “1” = 2.5 … 5 V (2-bit binary, answer between commands 30-70 ms, permissible load per channel 270 mA). – The module is powered by DC 4.5 – 5V. – All 16 channels are initially pulled to the ground with NPN control. Depending on the complexity of your project, the number of plug-in modules can reach up to 5 with their distribution by ports (16 – 240), which allows you to control up to 80 output channels. * The starter package includes 1 module for 16 channels.