BlueROV2 Enclosure w/ Pre-wired Electronics
$2,000.00
Description
- BlueROV2 Enclosure w/ Pre-wired Electronics
- Includes the enclosure and electronics from the BlueROV2
- Is pre-wired and ready to go
- Lets you build a custom ROV frame
The BlueROV2 Enclosure w/ Pre-wired Electronics includes the enclosure and electronics from the BlueROV2, pre-wired and ready to go! This is an excellent option if you are building a custom ROV frame and need a ready to use electronics and control solution!
If you have not assembled your BlueROV2 please see the Assembly Guide (/learn/bluerov2-assembly/) and assemble your BlueROV2 prior to setting up the software.
There are two computers installed on the BlueROV2: a Pixhawk autopilot, and a Raspberry Pi ‘companion’ computer. Before proceeding, we will check that the software on both computers is up to date and update the software if necessary. Some joysticks require calibration before you can enable them for use with QGround Control.
If your joystick requires calibration, the Joystick tab on the Vehicle Settings page will be red, and you should follow these steps to calibrate your joystick. If your joystick does not require calibration, the Joystick tab will not be red, and you can skip this step!
4″ Series Enclosure
- 1 x Extruded Acrylic Tube – 11.75″, 298mm (4″ Series)
- 2 x O-Ring Flange (4″ Series)
- 1 x Dome End Cap (4″ Series)
- 1 x Aluminum End Cap with 14 Holes (4″ Series)
- 1 x Enclosure Vent and Plug
Advanced Electronics
- 1 x Raspberry Pi 3 Model B Computer
- 1 x Low-Light HD USB Camera
- 1 x Single Fathom-X board
- 1 x ArduSub Raspbian MicroSD Card (16GB)
- 1 x 5V 6A Power Supply
- 1 x Pixhawk Autopilot
- 1 x Pixhawk Shelf and Mounting Hardware
- 1 x 6″ Left-Angle Micro USB Cable for Raspberry Pi to Pixhawk
- 1 x Blue Robotics Power Sense Module
- 1 x XT60 Female to Bullet Connector Cable (for Pixhawk Power Module)
- 1 x Ferrule to Spade Cable (for Fathom-X)
Electronics Tray
- 1 x Electronics Tray (4″ Series) (with Terminal Blocks and Hardware)
- 1 x Camera Tilt System (with Mount for USB Camera)
Other
- 6 x Basic ESC (new R3 version)
- 3 x Blank Penetrators
- 1 x Bar30 High-Resolution 300m Depth/Pressure Sensor
- 1 x BlueROV2 Power Cable
Size
- Length: 380 mm, 15 in
- Width: 114 mm, 4.5 in
- Height: 114 mm, 4.5 in
- Weight in Air: 2.25 kg, 5 lb
- Cable Penetrator Holes: 14 x 10 mm, 14 x 0.4 in
- Main Tube (Electronics Enclosure): Blue Robotics 4 inch series
Performance
- Maximum Rated Depth: 100 m, 330 ft
- Maximum Tested Depth (so far): 130 m, 425 ft
- Temperature Range: 0-40°C, 32-86°F
- ESC: Blue Robotics Basic 30A ESC
Sensors
- Gyroscope: 3-DOF Gyroscope (on the PixHawk)
- Accelerometer: 3-DOF Accelerometer (on the PixHawk)
- Compass: 3-DOF Magnetometer (on the PixHawk)
- Internal pressure: Internal barometer (on the PixHawk)
- Pressure/Depth and Temperature Sensor (external): Blue Robotics Bar30
- Current and Voltage Sensing: Blue Robotics Power Sense Module
Camera Tilt
- Tilt Range: +/- 90 degree camera tilt (180 total range)
- Tilt Servo: Hitec HS-5055MG
Camera
- Field of View (Underwater): 110 degrees (horizontal)
- Light Sensitivity: 0.01 lux
- Resolution: 1080p
Control System
- Tether Interface Board: Fathom-X Tether Interface Board
- Control Board: Pixhawk 1
- Control Software: ArduSub
MAECENAS IACULIS
Vestibulum curae torquent diam diam commodo parturient penatibus nunc dui adipiscing convallis bulum parturient suspendisse parturient a.Parturient in parturient scelerisque nibh lectus quam a natoque adipiscing a vestibulum hendrerit et pharetra fames nunc natoque dui.
ADIPISCING CONVALLIS BULUM
- Vestibulum penatibus nunc dui adipiscing convallis bulum parturient suspendisse.
- Abitur parturient praesent lectus quam a natoque adipiscing a vestibulum hendre.
- Diam parturient dictumst parturient scelerisque nibh lectus.
Scelerisque adipiscing bibendum sem vestibulum et in a a a purus lectus faucibus lobortis tincidunt purus lectus nisl class eros.Condimentum a et ullamcorper dictumst mus et tristique elementum nam inceptos hac parturient scelerisque vestibulum amet elit ut volutpat.
Reviews
There are no reviews yet.