MC Etcher – Drag Bit (Combo 90 and 120 Degrees)

• MC Etcher – Diamond Drag Bits
• Offers Combo pack: 90-degree tip & 120-degree tip
• Perfect for fine-line engraving on composites, metals, and glass
• Feedrate: 60 inch / min
• Plungerate: 30 inch / min
• Shank: 1/4 inch

The MC Etcher – Diamond Drag Bit (Combo 90 and 120 Degrees) is a perfect set for fine-line engraving on composites, metals, and glass. The 90-degree tip has better penetration in very hard or anodized materials. The 120 deg tip provides slightly wider lines in softer materials such as fiberboard but has less penetration in harder materials.

MC Etcher drags a diamond-coated, spring-loaded tip over the surface of your material to create an etched or engraved pattern, it does not cut with flutes like a normal endmill.

Note: The drag engravers are not meant to rotate so the spindle needs to be turned off when using MC Etcher.